Specifications

Removal and Disassembly
16 MAINTENANCE MANUAL
4. If necessary, remove the output shaft and
the bearing cones as an assembly from the
output bearing cage.
A. Place the output shaft and the output bear-
ing cage in a press. Figure 3.13.
B. Press the output shaft and cones bearing
cage.
C. Remove the outer cup from the output shaft.
5. Use a press or a bearing puller to remove
the bearing cones from the output shaft.
See the procedure in section 3.
Removal Bearing Cones the Output Shaft
Press Method
1. Place a used bearing cup on the inner bear-
ing cone
2. Place the output shaft into a press. Figure
3.14. The used bearing cup supports the out-
put shaft.
NOTE:
When you press the output shaft from the
cage, the bearing cup remains in the cage.
The outer cup is removed with the thru-shaft
and the cones.
Figure 3.13
Figure 3.14
PRESS
PRESS
USED BEARING
CUP