Specifications

Removal and Disassembly
14 MAINTENANCE MANUAL
5. Remove the output shaft bearing cage cap-
screws and washers.
6. Pull the bearing cage, bearings and shaft as-
sembly from the axle housing. If necessary,
loosen the cage from the housing with a soft
mallet. Figure 3.8
Removal differential assembly from the
Axle Housing
1.Place a hydraulic jack under the differential
assembly to support the assembly. Figure 3.9.
2. Remove all but the top two differential to housing
capscrews or stud nuts and washers. Figure 3.9.
3. Loosen, but do not remove, the top two dif-
ferential to housing fasteners. The fasteners
will hold the diferrential in the axle housing.
4. Loosen the differential assembly in the axle
housing. Use a plastic mallet to hit the differ-
entialmountingangeatseveralpoints.
5. After the differential is loosened, remove the
top two stud nuts and washers that hold the
assembly in the axle housing.
Figure 3.7
Figure 3.8
Figure 3.9
REMOVING THE
FLANGE
REMOVING
THE YOKE
HIDRAULIC
JACK
TOP TWO FAS-
TENERS
OUTPUT SHAFT AND DE BEARING
CAGE ASSEMBLY