Specifications

Vehicle Towing Instructions
112 MAINTENANCE MANUAL
2. Apply the vehicle spring or parking brakes
by manually releasing each spring that was
compressed before begin to transport. See
the vehicle manufacturer’s instructions.
3. Disconnect the auxiliary air supply, if used,
from the brake system of the vehicle that was
transported. Connect the vehicle’s air supply
to the brake system.
4. Remove the covers from the hubs.
NOTE:
Install the axle shaft(s) indicated in Table
AG. These Axle shafts have a double row of
splines that engage with the splines of the
side gear and shift collar in the differential
case. FIGURE 11.3.
5. Install the gasket, if used, and axle shaft into
the axle housing and differential in the same
location. The gasket and ange of the axle
shaftmustbeatagainstthehub.Rotatethe
axle shaft or the driveline as necessary to
alignthesplinesandtheholesintheange
with the studs in the hub. Figure 11.1.
6. Install the conical washers, if used, over each
studandintothetaperedholesoftheange.
7. Install the washers and capscrews or stud
nuts. Determine the size of the fasteners and
tighten the capscrews or nuts to the corre-
sponding torque value shown in Table AH.
1 - LEFT-HAND, ROADSIDE, AXLE SHAFT
2 - SHIFT ASSEMBLY
3 - SHIFT COLLAR
4 - RIGHT-HAND, CURBSIDE, AXLE SHAFT
5 - DOUBLE ROW OF SPLINES
6 - SHIFT COLLAR AND DIFFERENTIAL CASE SPLINES ENGAGED
OR LOCKED
7 - SIDE GEAR
8 - DIFFERENTIAL CASE
SINGLE AXLE OR REAR AXLE OF TANDEM SHOWN
WITH SCREW-IN DCDL SHIFT ASSEMBLY AND
SHOWN IN THE LOCKED OR ENGAGED POSITION
Table AG
Single
Axle
Remove the left side axle shaft inner side
of the road
Tandem
Axle
Front Axle
Remove the right side axle
shaft, outer side of the road
Rear
Axle
Remove the left side axle
shaft, inner inside of the road
Table AH
Type of Fas-
tener
Thread Size Tandem Axle
Capscrew
0,31”-24
0,50”-13
0,24-33 (18-24)
115-156 (85-115)
Stud Nuts/Plain
Nut
0,44”-20
0,50”-20
0,56”-18
0,62”-18
0,75”-16
68-102 (50-75)
102-156 (75-115)
149-224 (110-165)
203-312 (150-230)
420-542 (310-400)
Locknut
0,44”-20
0,50”-20
0,56”-18
0,62”-18
0,75”-16
54-88 (40-65)
65-100 (88-136)
136-197 (100-145)
176-258 (130-190)
366-475 (270-350)