Specifications

111
Vehicle Towing Instructions
MAINTENANCE MANUAL
7. Release conical washers, if used, of the
angeoftheaxleshaf.Figure.FIGURE11.1.
8. Identify each axle shaft to be removed from
the axle assembly so they can be installed
in the same location after transporting or re-
pair is completed.
9. Remove the conical washers, the axle shafts
and gaskets, if used. Figure 11.1.
10. Desconecte a mangueira de ar do cilindro
de acionamento do mecanismo de blo-
queio. FIGURE 11.2
11. Remove the manual engaging capscrew
from the storage hole. The storage hole of
threaded shift assemblies is located in the
shift tower of the differential, next to the cyl-
inder. FIgure 11.2.
12. Lock or gear the main differential using the
manual engaging capscrew. See the Sec-
tion 6.
13. Remove the remaining axle shaft(s) as nec-
essary from the axle(s) that will remain on
the road when the vehicle is transported
14. Install a cover over the open end of each
hub where an axle shaft was removed. This
will prevent dirt from entering the bearing
cavity and minimize loss of lubricant
NOTE:
If an air supply will be used for the brake sys-
tem of the transported vehicle, continue with
Steps 15 and 16, otherwise continue with
Step 17.
15. Connect an auxiliary air supply to the brake
system of the vehicle that is being trans-
ported. Before moving the vehicle, charge
the brake system with the correct amount of
air pressure to operate the brakes. Refer to
the instructions supplied by the manufactur-
erofthevehicleforproceduresandspeci-
cations. If an auxiliary air supply is not used,
continue with Step 17.
16. When the correct amount of air pressure
is in the brake system, release the parking
brakes of the vehicle that is being transport-
ed. Step 17 is not required.
17. If there are spring or parking brakes on the
axle(s) that will remain on the road when
the vehicle is transported, and they can-
not be released by air pressure, manually
compress and lock each spring so that the
brakes are released. See the manufactur-
er’s instructions.
Towing or Drive-Away
1. If an auxiliary air supply was used, apply the
vehicle parking brakes using the switch inside
the cab of the vehicle. If an auxiliary air supply
was not used, begin with Step 2.
CAPSCREW
MANUAL ENGAG-
ING
Figure 11.2
AIR HOSE
HOLE IN BED
CILYNDER
THREADED DCDL
AXLE
SHAFT OR
FLANGE
SHAFT
HUB AXLE
WASHER
PARAFUSO
NON CONICAL
WASHER
RETENTION
STUD
GASKET
CONICAL
WASHER
WASHER
STUD NUT
CONICAL WASHER
RETENTION
Figure 11.1