Specifications

Special Tools
108 MAINTENANCE MANUAL
How to Make a Fork Tool to Detencion
1. Measure dimensions A and B of the fork you
are servicing. Figure 10.1.
2. Calculate dimensions C and D of the fork bar
by adding 0.125-0.250-inch to dimensions A
and B of the fork. Figure 10.2.
4. Cut a 1,20 mt x 1.25-inch piece of mild steel
round stock to make the fork bar handle. Cen-
ter weld this piece to the box section. Figure
10.2.
• Toincreaseforkbarrigidity:Weldtwoangle
pieces onto the handle. Figure 10.2.
Unitized Pinion Seals and Seal Tools
See the Table AE and Figure 10.3 for informa-
tion on unitized pinion seals and seal tollss. To
obtain Meritor seal tools KIT 4454, see to the
Service Notes page on the front of this manual.
WARNING
Wear safe clothing and eye protection when
you use welding equipment. Welding equip-
ment can burn you and cause serious personal
injury. Follow the operating instructions and
safety procedures recommended by the weld-
ing equipment manufacturer
3. To make the box section, cut and weld 1-inch
x 2-inch mild steel square stock according to
dimensions C and D. Figure 10.2.
Figure 10.1
FORK
FORK TOOL TO DETENCION
Figure 10.2
INSTALATION
TOOL
FASTENER
HEAD
TOOL
R4422401
Position the seal
tolls to prevent
the driver spokes
from hitting the
fastener heads on
the forward tandem
output seals
Figure 10.3