Specifications
SpecicationsAdjustments
106 MAINTENANCE MANUAL
Table Z: utput Bearing — Clearance and Preload (See to Section 5)
Clearance input axle 0.050-0.200 mm (0.002-0.008”)
Tabela AA: Output Bearing — Clearance and Preload (See to Section 5)
Specication 0.025-0.102 mm (0.001-0.004”) Holgura en el Rodamiento.
Adjustment Clearance is controlled by the size of the snap ring in
the output bearing cage.
Increase end play by installing a thinner snap ring.
Decrease end play by installing a thicker snap ring.
NOTE: If the end play on the output bearing measures
ZERO, a thinner snap ring is required.
Tabela AB: Ring Gear — Backlash (See the Section 5)
Specication 145 Series:
Range: 0.008-0.018-inch (0.20-0.460mm)Backlash set-
ting for new gear sets: 0.012-inch (0.300mm)
160 Series:
Range: 0.010-0.020-inch (0.25-0.510mm)Backlash set-
ting for new gear sets: 0.012-inch (0.300mm)
Adjustment Backlash is controlled by the position of the ring gear.
Changebacklashwithinspecicationstogetagood
tooth contact pattern.
To increase backlash, move the ring gear away from the
drive pinion
To decrease backlash, move the ring gear toward the
drive pinion.
Tabela AC: Ring Gear — Runout (See the Section 5)
Specication 0.008-inch (0.200mm) Ring gear maximum observed with
main differential case in the difcoroa montada na caixa
dos satélites e na caixa do differential.
Tabela AD: Sensor Switch — Installation (With Differential Lock Only) (See the
Section 6)
Adjustment Shift the differential to the locked position.
Tighten the sensor switch in the differential until the test
light illuminates.
Tighten the sensor switch one additional turn.
Tightenthejamnuttothespeciedtorque.