User`s guide

Intel
®
StrongARM
®
SA-1110 Development Board User’s Guide 2-11
Getting Started
3. Slide the middle top section of the box away from the notch in E11. Open the right hand side
of the socket, then open the left hand side of the socket (see Figure 2-9).
4. Using the Pen Vac tool, remove the low side (bits 0-15) StrataFlash memory component from
the shipping container.
5. Insert the low side StrataFlash memory component into the socket aligning the pin 1
indicators.
6. Close up the socket.
7. Repeat steps 2 through 5 for the socket on side 2 for the high side (bits 16-31) StrataFlash
memory component. See Figure 2-10 for locating and aligning E12 on side 2.
Figure 2-9. Opening the E11 Socket
A7484-01