User`s guide

2-8 Intel

StrongARM

SA-1110 Development Board

User’s Guide

Getting Started

Caution: The following procedure assumes that the jumper (shunt) for J22, the Master Power Clip for the

Li-ion battery, has been disconnected and that all power associated with the SA-1110 Development

Board is off. For more information about Li-ion battery considerations, see Chapter 6.

Note: A very high value capacitor of 0.33 Farads (super cap) is connected in parallel with the battery

through J22. This capacitor provides enough power to support the system for several minutes in

sleep mode while the battery is being changed.

1. Verify that the AC adapter power jack that is not connected to J10 (see Figure 2-4 for the

location of J10).

2. Verify that the Li-Ion battery is installed on the SA-1110 Development Board and that the

battery harness is connected to J4 (see Figure 2-6 for the location of the Li-Ion battery).

Figure 2-5. Power Input Jack Location

A7615-01

J10

J11

J17

J16

J14

Headset Jack

2.5 mm

USB Type B

Connection

Stereo Jack

3.5 mm

Base Station

Power Input Jack

Figure 2-6. Li-Ion Battery Location

A7371-

Li-lon Battery

Plexi Glass

1.5"

3.4 cm

5 cm

Note: Not actual size