Operation Manual

2
E
Contents
Introduction .....................................................................................................................................................................................3
System Requirements ................................................................................................................................................................3
Installing ..........................................................................................................................................................................................4
Connecting Peripheral Equipment ................................................................................................................................................5
About This Software .......................................................................................................................................................................6
Starting up the software ..............................................................................................................................................................6
Creating/Editing Target Values ......................................................................................................................................................7
Creating a new target value le ..................................................................................................................................................8
Editing a target value le ............................................................................................................................................................9
Calibration and Measurement .....................................................................................................................................................10
Manual Adjustment ......................................................................................................................................................................14
Reference Monitor Emulation ......................................................................................................................................................15
Uninstalling the Software ............................................................................................................................................................16
Important Information
• This software has been shipped after strict quality control and product inspection. If, however, you nd any failure or
malfunction, contact your product dealer.
• Please understand that SHARP CORPORATION bears no responsibility for errors made during use by the customer or a
third party, nor for any other malfunctions or damage to this software arising during use, except where indemnity liability is
recognized under law.
• Transcribing or duplicating part or all of this manual and/or this software without permission from our company is not
permitted.
• As a part of our policy of continuous improvement, SHARP reserves the right to make design and specication changes for
product improvement without prior notice.
• The contents or details may vary depending on the screen conguration and OS version, etc.
• This manual does not contain basic operating instructions for Windows.
• This manual assumes use in landscape orientation, except where specically noted.
• Individual di󰀨erences of colorimetric sensor or measurement errors may a󰀨ect calibration results and measurements. After
adjustment, be sure to observe the results and adjust manually.
Trademarks
• Microsoft and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or
other countries.
• i1Pro 3 Plus and i1-series products are registered trademarks of X-Rite Incorporated in the United States and/or other
countries.
• All other brand and product names are trademarks or registered trademarks of their respective holders.