Operation Manual

12
E
“Start calibration” screen
(“Start measurement” screen in the case of measurement)
When “Update the date and time of the monitor” is checked,
time settings of the computer and monitor will be synchronized.
8. Click “Start”.
“Calibration” or “Measurement” starts.
Display of the monitor to be calibrated changes.
“Calibration in progress” screen
(“Measurement in progress” screen in the case of
measurement)
During calibration or measurement, the screen shown on
the right is displayed on the monitor which is being adjusted.
(It may take a couple of minutes until it is displayed.)
Press the [ESC] key, and then press the [ENTER] key to abort
the process.
If you want to continue the process after pressing the [ESC] key,
press the [ESC] key again.
If Display Calibration Utility is displayed on a monitor other than
the one to be adjusted, the scrren shown on the right is displayed
on it.
(1) Aborting the calibration
(Aborting the measurement in the case of measurement)
Click “Abort”, and then click [OK] on the dialog box to abort
the process.
If you want to continue the process after clicking “Abort”,
click [Cancel].
(1)
Caution
• If the monitor power is turned o󰀨 or the USB cable is disconnected before “Calibration” or “Measurement” is completed,
monitor settings, the settings of “POWER MANAGEMENT” in the SETUP menu and the PICTURE menu may change.
In that case, recongure the settings to the state before adjustment, and retry “Calibration” or “Measurement”.
• If the monitor is turned o󰀨 or the USB cable is disconnected before completing “Calibration”, the power LED of the monitor
blinks in green at the next startup of the monitor, and settings except “POWER MANAGEMENT” revert to the state before
adjustment.
In that case, recongure “POWER MANAGEMENT” of the monitor to the state before adjustment, and retry “Calibration”.
Calibration in progress
Do not touch the colorimetric sensor or display during calibration.
* Press the [ESC] key on the keyboard to abort calibration.
[PROGRESS: 30 %]
Power LED