Operation Manual

11
E
For the colorimetric sensor, refer to its operation manual.
Follow the instructions on the screen of Display Calibration Utility to initialize or install the colorimetric sensor and perform
“Calibration” and “Measurement”.
When “Calibration” is selected, “Calibration” is performed, and then “Measurement” is performed.
When “Measurement” is selected, “Measurement” is performed without “Calibration”.
Caution
• Do not touch the monitor screen. Display unevenness may occur, which a󰀨ects the result of “Calibration” or “Measurement”.
When installing the colorimetric sensor to the monitor, handle it gently so that the colorimetric sensor touches the monitor
surface softly, in order to prevent display unevenness.
“Colorimetric sensor initialization” screen
(1) (
) Play video, ( ) Expand video
If initialization of the colorimetric sensor is already completed,
following dialog box is displayed, and the initialization
can be skipped.
6. Click “Next”.
Initialization of the colorimetric sensor will be performed.
“Colorimetric sensor installation” screen
Install the colorimetric sensor to the monitor on which “Calibration”
or “Measurement” is to be performed.
Make sure that the contact surface of colorimetric sensor does not
leave the monitor surface.
(2) Display a crosshair on the monitor
Align the colorimetric sensor with the center of the crosshair
displayed on the monitor and install it.
Remove a crosshair on the monitor
Remove the crosshair displayed on the monitor.
In the case of landscape orientation, a crosshair is
displayed at the center of the monitor.
In the case of portrait orientation, a crosshair is displayed
at the top of the monitor.
7. Click “Next”.
Conrm the colorimetric sensor installation and congure colorimetric sensor settings.
The monitor display changes.
Caution
• Do not touch the monitor or colorimetric sensor until “Calibration” or “Measurement” is complete.
• Do not operate any other software until “Calibration” or “Measurement” is completed.
• When performing “Measurement”, set “LUMINANCE CLIPPING”, “GAMUT WARNING”, “MARKER”, “PEAKING”, “FALSE
COLOR”, and “MONO/BLUE ONLY” in the EXTENSION menu of the monitor settings to “OFF”. If an item is grayed out, it is
already set to “OFF”.
• If initialization of the colorimetric sensor fails, the colorimetric sensor may not be connected to the computer properly, or the
software for colorimetric sensor is not installed.
• If sunlight or ambient light is too strong, calibration or measurement may not be performed properly.
(1)
(2)
(1)