66GS-62H COLOUR TELEVISION OPERATION MANUAL
TERMS OF GUARANTEE Subject to the conditions listed below Sharp Electronics (U.K.) Ltd. (Hereinafter called «the Company») guarantee to provide for the repair of, or at its option replace the Sharp Equipment, or any component thereof, (other than Batteries), which is faulty or below standard, as a result of inferior workmanship or materials. The conditions of the guarantee are: 1.
Safety precautions This equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/EEC. To prevent fire or electrical shock, do not use the TV set in an excessively damp place. Never remove the back of the cabinet, as there is high voltage in the TV set. Please call for service. Position the TV set out of direct sunlight and away from heat, as high temperatures can damage the cabinet, CRT, or other electronic parts.
Contents Audio Adjustments .........................................................17 On Timer and Off Timer...................................................19 Child Lock (Channel Block) ............................................20 POSTCODE and VCR Mode ...........................................22 TV/VIDEO Selector .........................................................23 Sub-titles .........................................................................23 Headphone Jack ...........................
Remote Control 1. 19. 2. 20. 3. 4. 5. 21. 22. 6. 23. TV 1. Stand-by ON/OFF switch (TV) Video 2. Power ON/OFF switch (VCR) TV 3. Digit buttons 0~9 4. Flashback button Teletext 5. Colour button (green) 6. Colour button (red) TV 7. Volume Down/Cursor control left 8. Menu button Teletext 9. 10. 11. 12. 13. 14. Reveal button List selector Store button Cancel button Top/Bottom/Full button Reset button Video 15. 16. 17. 18.
Controls & Terminals FRONT TV 1. Main Power On/Off Switch 2. Power Indicator 3. Program Selector (UP/DOWN) 4. Volume Buttons (UP/DOWN) 7 8 5. Remote Control Sensor 6 5 4 3 6. Sound Indicator 7. Remote Control Indicator 8. DOOR Behind the door 9. Headphone Socket (3,5 mm Ø 16 ~ 600 ohms) n VIDEO L/S/G/I R/S/G/I AUDIO 9 HOW TO OPEN THE DOOR Press the top of the door, opening it slightly. Hook your finger inside and pull open. REAR TV 3 RF Input 1. Antenna terminal 21-pin In/Out 2.
Aerial connections - TV set only - Mains Outlet Socket AC 220~240V, 50 HZ Aerial connections - VCR and TV REAR OF TV Mains Outlet Socket AC 220~240V, 50 HZ SCART Lead (Not supplied) Aerial (Not supplied) Aerial Cable (Not supplied) Aerial Lead (Not supplied) Mains Outlet Socket AC 220~240V, 50 HZ RF out Aerial in Audio/Video NOTE: See on - Typical connections - (page 28) for details of further connection possibilities.
Auto Installation Auto Installation System Your television set is provided with an Automatic Installation System which makes installation easier. This new system is activated when you turn on the TV for the first time. Procedure: 1. Connect the antenna jack in the antenna input terminal on the rear side of your TV-set. Then connect the TV power cable to a 220 ~ 240V a.c. system. 2.
a) Select a programme to be edited Use this option to select a programme from the list. Each time you press CH / CH the memorised channel will be viewed and will remain selected on the list by means of a white background. b) Edit this program Use this option for giving a name made up of four digits to the channels or for changing the one which appears on some channels, in the following way: b.1. Select the channel using the Cursor UP/DOWN buttons CH / CH . b.2. Press the RED button. b.3.
Switching on Power supply on/off button This TV memorizes the Mode last used when it was switched off. When the main power button (®) is pressed to turn on the set, the power indicator will light and the set will resume in either the Stand-by mode or Programme mode, depending upon its condition when it was switched off.
Menu Structures This TV set has: a MAIN MENU with four basic menus, which permit access to the different functions of the TV. These menus are as indicated below.