Technical data

INITIAL SETTINGS
44
6
About the Liquid Crystal Display
The machine is equipped with a two-line liquid crystal display (LCD) on the
operation panel for displaying various messages and settings during operation.
This LCD can display up to 20 characters on each line. When the machine is
idle, the LCD shows the date, time, and the stand-by memory available.
Example:
Adjust the volume of both key beeps and alarm beeps (emitted at the end of
transmission and reception) using the procedure below.
Factory setting: 3 (MEDIUM)
Step Press these keys Comments
1 “OPTION SETTING” will
appear in the display.
2 “BEEP VOLUME” will
appear in the display.
3 Press the or key to
lower or raise the volume
to the desired level.
4 “STORED” will appear in
the display.
5 Press the STOP key twice
to exit.
FUNCTION
GHI
JKL
or
ENTER
STOP
Adjusting the Beep Volume
The left and right arrow ( ) keys on the operation panel of the machine
are very useful for scrolling through the various function lists and settings.
Once you have pressed the FUNCTION key, you can scroll through the ten
functions as desired. (See the Function mode at the top of the Quick Reference
Guide for the settings.) Pressing the ENTER key chooses the displayed
function. For many of the function lists, you can then use the arrow keys again
to scroll through the settings.
Using the Arrow Keys
Note: means this machine is in the Reverse Sending mode. It appears
when LCD shows “STAND-BY” or “SEND READY”.
STOP
SUK 06 INITIAL LEO.p65 30/03/00, 17:0044