User`s guide

RX100 S4 Options Guide 33
9 Upgrade kit hot-plug variant
V CAUTION!
Observe the safety instructions in the chapter “Safety notes” on page 11
et seq. .
9.1 Upgrading to hot-plug variant
Ê Open the server as described in the chapter “Preparation” on page 17 et
seq. .
Figure 16: Removing the non-hot-plug hard disks
Ê Remove the power connectors from the non-hot-plug hard disks.
Ê Remove the Y-cable from the connector P4 of the power supply.
Ê Remove the data cables from the non-hot-plug hard disk.
Ê Loosen the knurled screws.
Ê Push the non-hot-plug hard disks out of the bays frontward.