Specifications

Chapter 7: BIOS Updating Procedures 7-3
3. ApplypowertotheterminalsotheCD‐ROMdrivecanbeopened.
4. InserttheBIOSupdateCD.
NCRBIOSandBIOSUpdateSoftware
LPIN:A370‐0022‐0100
5. Boottheterminal.
6. PressF2atthescreenprompttoentertheSetupUtility.
7. IntheAdvanced
menu,selectI/O Device Configuration.
8. VerifythatLPT 1 Mode issetto ECP.
9. GobacktotheAdvancedmenu,selectMultiple ROM Menu.
10. SettheParallel CD-ROM BoottoEnabled.
11. ExitSetupandSaveChanges.
Astheterminalreboots,youshouldseeamessageduringboot
indicatingthattheCD‐ROMhasbeen
recognized:
Micro Solutions BACKPACK CD-ROM v0.3
. . .
Booting from BACKPACK CD
Starting MS-DOS
12. FollowthescreenpromptsontheclienttoupdatetheBIOS.You
canselecttwomethodstoruntheupdateprogram.
 AutomaticBIOSUpdate–updateprocessrunsunattended
Note: Youwillseeapromptforterminalmodelandserial
numberinformationiftheprogramdetectsinvalid information
in
thecurrentBIOS,orifyouarereplacingtheProcessorBoard,
inwhichcasethereisnotmodel/serialnumberinformationin
theBIOS.
Important:Model/SerialNumberismandatoryforFitClient
operation.
 InteractiveBIOSUpdate–permitsyoutoinput/replacethe
model/serialnumberinformationthatisstoredintheBIOS.