Specifications

Chapter 7: BIOS Updating Procedures
Introduction
TheterminalʹsBIOScanbeupdatedusingaparallelCD ‐ROMdrive
andsoftwareavailableonbootableCD‐ROMmedia.Thedrivers
necessarytoruntheCD‐ROMaretemporarilyinstalledduringboot.
Thischapterdescribesthisprocedure.
ItisalsopossibletoperformaBIOSupdateusinganetwork

connection.RefertotheNCRFitClientSoftwareUserʹsGuidefor
informationaboutthatprocedure.
Crisis Recovery
IntheeventtheBIOSbecomescorrupt,suchastheresultofapower
failureduringtheBIOSUpdateprocedure,youcanusethemethod
discussedlaterinthischapterintheBIOSCrisisRecoverysectionto
recovertheBIOS.
Prerequisites
Thefollowingarerequiredonthe7401inordertoperformaBIOS
updateusingaCD.
 BootableCD‐ROMdrive
 Integrated7401‐F058/F059
 External2336‐K007(ParallelCD‐ROM–Series5orSeries6)
 TheterminalBIOSmustbe1.02.00.00orgreater.
 MicroSolutionsBackPack
CD‐ROMSeries6requiresBIOS
2.1.1.1orgreater
 Keyboard
 NCRBIOSandBIOSUpdateSoftware
(LPIN:A370‐0022‐0100)