Specifications

Chapter 5: Setup 5-5
Configuring a Hard Drive
Note: PrimaryMaster,SecondaryMaster,PrimarySlaveand
SecondarySlaverefertotheIDEdrives.
Afterinstallingaharddrive,youneedtoconfiguretheharddrive
usingSetup.Performthefollowingsteps:
1. OntheSetupMainmenu,selecttheappropriateIDEAdapter(such
as,PrimaryMaster)fieldand
pressEnter.Asub‐menudisplaysfor
thePrimaryMasterdrivethatyouselected.
2. PressEnterontheTypefield.Theworkstationautomaticallyfills
outtheremainingfields,dependingontheinstalleddrive.
3. MovethecursortotheExitmenu,selectExitSavingChangesand
pressEnter.
Setting Memory Cache
Thedefaultsettingenablesmemorycache.Ifyourapplicationrequires
memorycachetobedisabled,youcanchangeitbyperformingthe
followingsteps:
1. MovethecursortotheCacheMe moryfieldontheAdvancedmenu
andpressEnter.TheCacheMemorymenudisplays.
2. SelectEnabledinthe
MemoryCachefieldtoenablethememory
cache.
3. Settheotherfieldsonthismenuasdesired.SelectHelpformore
information.
4. MovethecursortotheExitmenu,selectExitSavingChangesand
pressEnter.