Specifications

5-4 Chapter 5: Setup
Setting Passwords
Tosetpasswords,performthefollowingsteps:
1. MovethecursortotheSetSupervisorPasswordselectionandpress
Enter.TheSetSupervisorPasswordmenudisplays.Fromthismenu,
thepersonsettingupthepasswordsystemcansetthesecurity
password.Userscansetuserpasswords.
2. Movethecursor
totheExitmenu,selectExitSavingChangesand
pressEnter.
Note: Onlyclearapasswordafterobtainingthepermissionofthe
responsiblesupervisor.
Ifthesupervisorpasswordislost,itcanbeclearedbyshortingthe
appropriatepinsonthemainprocessorboard.Forthelocationofthese
pins,
refertotheEasyPoint7401HardwareServiceGuide.
Iftheuserpasswordislost,andthesupervisorisnotavailable,then
theaboveprocedurecanbeusedtoclearthesupervisorpassword.
Thennewsupervisoranduserpasswordscanbedefined.