Specifications

Chapter 5: Setup
Introduction
ThischapterdescribeshowtoconfiguretheBIOSCMOSoptions.
FollowingthisIntroduction,therearesectionsspecificto7401‐
22xx/35xx/45xxterminalswithBIOSVersion2.2.1.x(Pentium
III/Celeronprocessors),7401‐26xx/46xxterminalswithACPIBIOS
Version2.3.x.x(PentiumIII/Celeronprocessors),andto7401‐21xx/31xx
terminalswithBIOSVersion1.5.0.4(Pentiumprocessor).
Thisolder
BIOS,version1.5.0.4,isdiscontinuedbutisincludedinthischapterfor
referencepurposes.
Note: Anexternalalphanumerickeyboardisnotrequiredtorunthe
BIOSCMOSSetupUtility,butakeyboardmakesthesetupeasier.
Entering Setup without a Keyboard
1. Applypowertotheterminal.
2. Calibratethetouchscreen.
a) WhenthescreenpromptthatsaysTouchthescreentwotimesto
enterSetupappears,touchthescreenthreetimes.Thiscauses
thesystemtobypasstheBIOSSetupandgodirectlytothe
TouchScreenCalibrationSetup.With
PentiumIII/Celeron
terminals,youwillnotseethispromptiftheBoot‐Time
DiagnosticsScreenisdisabled,butyoucanstillentersetupby
touchingthescreenthreetimes.
Note: SetupcanalsobeenteredfromtheBootMenuthatis
displayedwhenyoupressESCduringPOST.