Specifications

Chapter 4: 7401-4xxx Hardware Installation 4-19
Tolocatethe7401‐4xxxterminalsotheedgeoftheKeyboardTray
isevenwiththeedgeofthetabletop,locatethefrontedgeofthe
TableTopMount210mm(8.25in.)fromtheedgeofthemounting
surface.
2. Drillpilotholesorthroughholesfor
themountingscrews(4)or
mountingbolts.Screwsorboltsusedformountingtheterminalare
notprovidedwiththemountandmustbepurchasedlocally.The
holesinthemountarexxmm(xxin.)indiameter.
3. Drilltheholetoroutethecablesoutthebottomofthe
terminal,if
usingthatcableroutingsolution.
4. SecuretheTableTopMounttothemountingsurface.
Note: WhenthefrontedgeoftheTableTopMountislocatedaway
fromtheedgeofthemountingsurface,itmaybenecessaryto
removetheMotorizedCardReader,Keyboard,andSliding
Drawer
assemblybeforeplacingtheterminalontothemounttoprovideaccess
tothemountingscrews.Refertothe“AccessingtheMounting
Screws”sectionbelowfordetails.
5. LowertheterminalontotheMountaligningthelockingpins(4)on
thebottomoftheterminalwiththeslotsinthemount.

Caution: Usecarewhenliftingtheterminal.The7401‐4xxx
terminalweighsapproximately90lbs.(40.8kg).
6. Pushtheterminaltothebackuntilthelocatingpins(2)intheback
ofterminalarefullyengagedintotheholesinthemount.
7. Securetheterminaltothemount
usingthe8x32screws(2).