Specifications

4-14 Chapter 4: 7401-4xxx Hardware Installation
Removing Paper from the Printer Feed Rolls
Ifpaperbecomesjammedintheprinterfeedrolls:
1. UnlockthecabinetKeylock.
2. RaisethebottomoftheDisplayModuleDooruntilfullyopenand
supportedbytheGasShock.
3. SlidetheKeyboardTrayforwarduntilitstops.
4. Lifttheprintheadlever.
5. Loosenthetwothumb
screwsandremovetheFrontPaperGuide
Cover.
6. Removethepaper.
Note: YoucanalsofeedpapermanuallyusingtheFormFeedbutton
onthePrinterSwitchandDisplayPanel.Refertothe“UsingthePrinter
TestandDisplayPanel”sectionfordetails.
Removing Power from the Printer
TheprinterhasanOn/Offswitchlocatedonthebackoftheprinterand
hasaseparatePowerSupplylocatedundertheprinter.ThePrinter
PowerSupplyispluggedintothebottomconnectorofthePowerStrip
insidetheterminalcabinet.Useeitherofthefollowingmethodsto
removepower:

PresstheOn/OffSwitchtotheOffposition.
 UnplugthePrinterPowerSupplyplugfromthePowerStrip.