Specifications

3-58 Chapter 3: 7401-2xxx/3xxx Hardware Installation
5. TheMicroTouchCalibrationdialogboxthenappears.Donottouch
thescreenuntilthisdialogboxisnolongerdisplayed.

6. FromtheCalibrationCompletescreen,selectDone.
7. SelectClosetoexittheMicroTouchprogram.
8. FromtheControlPanel,selectFileClose toexittheControl
Panel.
Calibration Using Microcal (DOS)
Thecalibrationprogramlooksatwhereyourfingeriswhenyouliftit
offthescreen,notwhereyoutouchit.Therefore,calibratethescreenas
follows:
1. Touchthescreennearthecalibrationtarget.
2. Keepyourfingeronthescreenandslideittothecenterofthe
target.

3. Holdyourfingerfirmlyonthetargetfortwoseconds,thenliftitoff
quickly.
4. Verifythatthecalibrationwassetaccuratelybeforemakinga
servicecall.Performthecalibrationagainifnecessary.