Specifications

3-48 Chapter 3: 7401-2xxx/3xxx Hardware Installation
Completing the OS Installation (Win98) - (Discontinued)
Thesystemautomaticallyrebootswhentheimagerecoveryiscomplete
andstartsthesoftwareinstallation.Thisinstallationalsoinstallsmost
oftheadditionalsoftwareanddriversthatareincludedinthedisk
image.Completetheinstallationasfollows.
1. WhentheterminalbootsitenterstheWindowssetuproutine.
Note: When
installingWin98onterminalswithProcessorBoards
(7401‐21xx/31xx)therearefew differencesintheprocedureas
follows:
a) TheterminalstartstheAddNewHardwareWizard.
b) Foreachdevicefound,permitWindowstosearchfornew
drivers(takedefaults).
c) Aftereachdriverisinstalledyouareasked
toreboot.Answer
No.
2. AttheUser Informationscreen,entertheUserinformation.This
canbedoneusingakeyboardoryoucanusethetouchscreen
keyboard.Afterenteringtheinformation,pressEnterortouchOK.
3. GointotheControlPanelandsettheterminalDateandTime.

4. IntheControlPanel,runtheMicroTouchscreencalibration.