Specifications

Chapter 3: 7401-2xxx/3xxx Hardware Installation 3-11
Cable Routing
TheTiltMounthasthreeplacestosecurecablestothebaseoftheunit
byusingacabletiewrap.Remove thepowersupplycoverorcustomer
displayfromthebaseoftheunit,twothumbscrewsonbottomrear,
anduseatiewraptosecuretheEthernetcable
tooneoftheprovided
moldedcabletieholdersonthebase.Thisshouldprovidesufficient
strainrelieftopreventthecablefrombecomingtightanddamagingthe
connectorontheProcessorBoard.
TheperipheralcablesarerouteddownthroughtheMountAssembly
andouttherearoftheunit.
16413a
Bottom View
