Instruction manual

2) With a digital capacitor tester, measure the
start and run capacitance by placing the test
clips on position 4 and position 6 of the
terminal board M1 (Figure 722, shows 277uf,
OK). This number is the combination of the
start capacitor CA(180uF) + run capacitor(s)
CB(35uF) = 250uF +/- 10%. If the total is
outside this range, check each capacitor as
follows.
3) The start capacitor CA(180uF) is located on
the cover of the control box (Figure 723
shows 196uF, OK). Detach the two insulated
spade connectors. With the digital capacitor
meter, measure the capacitance. It should
be 180uF +/- 10% (162 to 198 uF). If the
reading is outside this range, replace the
start capacitor {Code #19196 (110 V),
#38546 (220 V, Pos. 31}.
4) The run capacitor CB(35uF) is located in the
control box and is larger in size than the start
capacitor (Figure 724, shows 39uF, OK).
Detach the two insulated space connectors
from the capacitor and attach the digital
capacitor meter clips to the capacitor.
Measure the capacitance. It should read
35uF +/- 10% (32 to 38uF). If the reading is
outside this range, replace the run capacitor
{Code #23686 (110 V), #42766 (220 V),
Pos. 32}.
Remember that all the previous test
s/rules
also apply to the (20mF & 60mF) 220 V
Capacitors.
Note: The 220 V XE301P only contains one
run cap
aitor.
56
Figure 721
Figure 722
Figure 723
Figure 724