Instruction manual

26) Put the cast aluminum brake end shield on
the motor shaft (See Figure 652).
27) Realign the switch and retighten the 3 M4x16
screws {Code #16996, Pos. 30, Figure 629}.
Place silicone around the bottom of the cast
aluminum end shield to seal the joint
between the winding and shield.
28) Place the motor shaft assembly into the
winding, align the marks and tighten the 4
M5x153 {Code #26097, Pos. 12} bolts.
29) Reassemble the brake per Section 5-12.
30) Replace the fan cover. Refit the motor and
test.
49
Figure 652