Instruction manual

21) Replace the bearing cover {Code #27935,
Pos. 6, Figure 637} and reaffix the snap ring
{Code #536, Pos. 20, Figure 636}. Repack
the ball bearing with grease. Note that the
seal is on the bottom and the bearing is open
to the top (See Figure 646).
22) With a metal tube (Figure 647) tap the
bearing onto the shaft until it contacts the
snap ring below it (See Figure 618).
23) Replace the snap ring {Code #536, Pos
20} on the shaft (See Figure 630).
Sqeeze the mechanical portion of the
centrifugal switch while sliding it up the shaft
(See Figure 651). With the set screw lock it
into position on the shaft (See Figure 628).
23) Manipulate the new switch to see if it opens
and closes properly (See Figure 649).
24) Reattach the wires to the switch (Figure 650).
25) Check the winding for burns or damage (See
Figure 651).
48
Figure 648
Figure 646
Figure 649
Figure 647
Figure 650
Figure 651