Instruction manual

11) Remove the motor shaft assembly {Code
#26587, Pos. 15, Figure 627}.
12) Loosen the set of screws holding the
mechanical part of the centrifugal switch
(See Figure 628) and push the assembly
away from the ball bearing to allow room for
a puller (See Figure Figure 629).
13) Remove the ball bearing 6004-RS1 {Code
#16536, Pos. 18} by removing the snap ring
{Code #536, Pos. 20, Figure 630} and pulling
with a bearing puller (See Figures 631 and
632).
45
Figure 627
Figure 630
Figure 628
Figure 631
Figure 629
Figure 632