Instruction manual

6) Mark the position of the white centrifugal
switch for easy alignment during reassembly
as shown in Figure 621.
7) Loosen the 2 screws holding the centrifugal
switch wires and remove the 2 spade
connectors from beneath the screws (See
Figures 622 and 623).
8) Unscrew the 3 M4x16 screws {Code #16996,
Pos. 30} holding the centrifugal switch (See
Figure 624).
9) Mark the flange for reassembly (See Figure
625).
10) With a rubber mallet, tap the cast aluminum
brake end bell {Code #26107, Pos. 5, Figure
626}.
44
Figure 621
Figure 624
Figure 622
Figure 625
Figure 623
Figure 626