Instruction manual

10) Remove the small thermal protector wires
from grey X1 and X2 (Figure 612).
11) Remove the four socket head cap screws
and lock washers that are holding the control
box to the motor. Remove the control box
(Figure 613).
12) Replace the old winding with a new winding
as shown in Figure 614.
6-2 Centrifugal Switch Replacement XE301P
1) Remove the motor and control box from the
hoist (See Figure 615 on the next page).
Remove the fan cover 4x8mm hex head
screws {Code #16086, Pos. 31}.
42
Figure 613
Figure 612
Figure 614
WARNING
Discharge the start and run capacitors
before proceeding.