Instruction manual

6) MOTOR
6-1 Replacement of Motor Winding (Stator)
1) Remove the fan cover M5x10 hex screws
{Code #16086, Pos. 31} as shown in Figure
601.
2) Remove the fan snap ring {Code #3866,
Pos. 21} shown in Figure 602.
3) Remove the fan {Code #16186, Pos. 7} using
two screwdrivers. Placed them under the fan
and against the motor shaft. Pry upward.
(Figure 603).
4) Remove the whole brake assembly {Code
#49746 (110 V), or #47406 (220 V) Pos. 35}
by removing the three socket head fixing
screws w/locking washers. (Figure 604).
5) Remove the brake disc {Code #47416, Pos.
38} and the brake hub {Code #47426, Pos.
39}. Remove the snap ring {Code #536, Pos.
20} and carefully pry the hub from the motor
shaft as shown in Figure 605.
40
NOTE:
The motor and control box must be removed
before attempting to replace the motor winding
(stator).
Figure 601
Figure 602
Figure 605
Figure 603
Figure 604