Instruction manual

3) Tighten down the three socket head fixing
screws w/locking washers.
4) Measure the air gap as shown in Figure 524.
If necessary, repeat steps 1-3 until an air gap
of 0.012" (0.3mm) is achieved.
5) Remove each of the three socket head fixing
screws separately and apply a bead of
silicone (Figure 525) to the tip to prevent
water entry into the motor. Replace all three
screws.
5-8 Release Strirrup Replacement
1) Carefully remove all sealant (Figure 526) if
the brake release stirrup is to be replaced.
2) Use a C-clamp to hold the brake assembly
together as shown in Figure 527.
3) Unscrew the two fixing screws as shown in
Figure 528 (“E” in Figure 530 on next page).
4) Install the new brake release stirrup (B)
{Code #61716, Pos. 40}.
5) Install the new fixing screws (Figure 529).
37
NOTE:
The adjustment of the gap on the brake release
stirrup has NOTHING TO DO with the adjustment
of the air gap of the brake!
Figure 524
Figure 525
Figure 526
Figure 527
Figure 528
Figure 529