Instruction manual

35
6) Remove the brake rotor {Code #47416, Pos.
38} and inspect it (Refer to Section 5-6).
Replace if worn or damaged (Figure 517).
7) Remove the snap ring {Code #3866, Pos. 21}
and carefully pry the brake hub {#47426,
Pos. 39} and key {Code #16256, Pos. 23}
from the motor shaft as shown in Figure 518.
Inspect the brake hub and replace if
necessary.
8) Inspect the friction plate {Code #62026, Pos.
36} for wear (Figure 519). Replace all worn or
damaged components.
5.5 Reassembly
1) Place the friction plate {Code #62026, Pos.
36} over the motor shaft. Rotate it until the
holes of the friction plate are directly over the
3 brake end shield holes.
2) Position the key {Code #16256, Pos. 23}
onto the motor shaft and slide the brake hub
{Code #47426, Pos. 39} down to the bottom
of the shaft. Place the snap ring {Code
#3866, Pos. 21} on top of the brake hub to
secure it.
3) Slide the brake disc {Code #47416, Pos. 38}
down the motor shaft so it fits over the brake
hub.
NOTE:
It is not necessary to unwire the brake
.
NOTE:
Care must be taken when replacing the hub not to
damage it.
NOTE:
Prior to reassembly, it is MANDATORY that the 3
brake end shield holes have silicone applied to
seal the screws. This must be done to prevent
water entry into the motor (Figure 520).
Figure 518
Figure 519
Figure 517
Figure 520