Instruction manual

15) Using a rubber dead blow mallet, hit the shaft

pinion {Code #22367, Pos. 5} as shown in

Figure 424. After several careful hits, the

pinion gear assembly should come out

through the front of the gearbox.

16) Inspect the pinion and bearing for any wear,

damage, or discoloration (Figure 425).

17) If a press is available, carefully press the

complete worm gear assembly from the top

of the gearbox out of the bottom of the

gearbox (Figure 426).

17a) If no press is available, carefully tap the

worm gear assembly with a hammer or brass

punch from the top of the base out the bottom

of the base as shown in Figure 427.

18) Once the worm gear exits the base, the lower

bearing {Code #40996, Pos. 16} must be

removed (Figure 428).

19) Install the gear puller as shown in Figure 429

and remove the bearing.

Figure 424

Figure 425

Figure 426

Figure 427

Figure 428

Figure 429