Instruction manual

9) Remove the snap ring {Code #536, Pos 13}
that sits on the input shaft (Figure 418).
10) Remove the seal {Code #39306, Pos. 23,
Figure 419}. The seal is destroyed during
removal and must be replaced after
reassembly of the gearbox.
11) Remove the large internal snap ring {Code
#16576, Pos. 22} as shown in Figure 420.
12) Remove any and all spacers {Code #25136,
Pos. 21} as shown in Figure 421.
13) Carefully turn the gearbox over and remove
the cup seal {Code #39376, Pos. 39} at the
bottom of the hoist as shown in Figure 422.
Dispose of the old seal.
14) Remove the internal snap ring {Code
#37796, Pos. 38} under the cup seal (Figure
423).
23
Figure 418
Figure 419
Figure 420
NOTE:
There may be more than one spacer below the
internal snap ring.
Figure 421
Figure 423
Figure 422