User manual

Chapter 5: Installation and Wiring
A
2
3
4
5
3
3
3
3
3
3
3
3
3
3
3
3
3
5–13
Hardware User Manual, 4th Edition, Rev. B
Installing the I/O Modules
WARNING:Do not apply field power until the
following steps are completed. See hot-
swapping procedure for exceptions.
Align
here
Align
here
Step Three: Attach field
wiring using optional terminal
block or ZIPLink wiring system
and install cover.
Step One: Align circuit card with slot
and press firmly to seat module into
connector.
WARNING:Explosion hazard – Do not connect or disconnect connectors
or operate switches while circuit is live unless the area is known to be
non-hazardous. Do not hot-swap modules unless the area is known to
be non-hazardous.
To install or remove
terminal block cover,
press middle to flex
cover.
Step Two: Pull top and
bottom locking tabs toward
module face. Click indicates
lock is engaged.
WARNING: The Productivity3000 PAC supports Hot Swap. Individual modules, expansion bases, and
entire remote base groups can be taken offline, removed, and replaced while the rest of the PAC system
continues controlling your process. Hot Swapping is performed with a HOT (powered) system. EXTREME
care must be taken to prevent damage to components, terminal blocks, or even personal injury due to a
short circuit from the live terminal block. Before attempting to use the hot swap feature, be sure to read
the hot swap topic in the ProductivitySuite Help file for details on how to plan your installation for use of
this powerful feature.