User manual

Chapter 5: Installation and Wiring
A
2
3
4
5
3
3
3
3
3
3
3
3
3
3
3
3
3
5–11
Hardware User Manual, 4th Edition, Rev. B
Installing the Power Supply
Step Two:
Insert the Power
Supply at a 45° angle
into the notch located
at the top of the base
and rotate down until
seated in socket.
Step Three:
Snap the two retaining
tabs into the locked
position.
Step One:
Locate the left most
socket in the base.
WARNING:Explosion hazard – Do not connect or disconnect connectors
or operate switches while circuit is live unless the area is known to be
non-hazardous. Do not hot swap.