User manual

Using Mounting Rails
The Productivity3000 bases can be secured to the cabinet using mounting rails. You should
use rails that conform to DIN EN standard 50 022. We offer a complete line of DIN rail,
DINnectors and DIN rail mounted apparatus. These rails are approximately 35mm high, with
a depth of 7.5mm. If you mount the base on a rail, you should also consider using end
brackets on each side of the base. The end brackets help keep the base from sliding
horizontally along the rail. This helps minimize the possibility of accidentally pulling the
wiring loose.
If you examine the bottom of the base, you'll notice retaining clips. To secure the base to a
DIN rail, place the base onto the rail and gently push up on the retaining clips. The clips lock
the base onto the rail. To remove the base, pull down on the retaining clips, slightly lift up the
base, and pull it away from the rail.
Chapter 5: Installation and Wiring
A
2
3
4
5
3
3
3
3
3
3
3
3
3
3
3
3
3
Hardware User Manual, 4th Edition, Rev. B
5–10
Rotate base
into position.
Hook base
onto DIN rail at
top of mount-
ing slot.
Gently push up
retaining clips.
1
2
3
Retaining Clips
DIN Rail
Dimensions
7.5 mm
35 mm
End Bracket (Part No. DN-EB35)
DIN Rail (Part No. DN-R35S1)