Contents Safety Precautions .................................................. 2 Supplied Accessories .............................................. 4 Remote Control Buttons ......................................... 5 Control Panel Buttons ............................................. 6 Antenna Connections .............................................. 6 Preparation ............................................................... 7 Teletext ...................................................................
Safety Precautions This equipment complies with the requirements of Directives 89/336/EEC, 92/31/EEC and 73/23/EEC as amended by 93/ 68/EEC. This receiver should only be operated from a 220-240V AC, 50 Hz outlet.Ensure you select the correct voltage setting for your convenience. Television equipment and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the equipment and cart combination to overturn.
Unplug the power cord from the wall outlet immediately if the TV set begins to make unusual noises or give off smoke or an odd smell, then call your dealer for service. Always disconnect your television from the mains and the aerial cables during thunderstorms. Even if your television is switched off, it can still be damaged by lightning striking the mains and/or aerial cable. Do not leave your TV set in Stand-by or operating mode when you leave the house.
Supplied Accessories 5HVSHFW WKH HQYLURQPHQW DQG SXW XVHG EDWWHULHV LQ D FRQWDLQHU WKDW LV HVSHFLDOO\ GHVLJQHG IRU WKLV SXUSRVH /) (& &2/285 7(/(9,6, 21 23(5$7,21 0$18$/ ,QVWUXNFMD REVáXJL WHOHZL ]RUD NRORURZHJR 6=Ë1(6 7(/(9Ë=,Ï.e6=h/e. .(=(/e6, Ò7087$7Ï 1iYRG N SRXåLWt EDUHYQp WHOHYL]H )$5(%1é 7(/(9Ë=1< 35,-Ë0$ý 35(9È'=.29È 35Ë58ý.$ 3 O H D V H U H D G WK L V RS H U D W LR Q P D Q X D O F D U H I X O O\ E H IR UH XV L QJ WK H F R O R X U WH O H Y L V L R Q QL H S U] H
Remote Control Buttons = Stand By = Cursor Up = Cursor Right OK = OK = Info (Program Menu) 0 - 9 = Direct Program -/-- = Double Digit = Wide mode button P/CH+ = Program + + = Volume + = TV / Quit Menu (;7 = EXT button (EXT-1, RGB, EXT-2, F-AV, S-VHS) Yellow = Feature Menu Blue = Installation Menu = Hold = Update = Index Page = Reveal = Expand = Mix = Teletext = Time Red = Sound Menu Green = Picture Menu = Mute I-II = Mono/Stereo - Dual I-II - = - Volume - P/CH = -Program = Flash back b
Control Panel Buttons 6 9,'(2 9 ,'(2 / 6 * , 5 ' ' ' $ 8', 2 6 9,'(2 9,'(2 / 6 * , 5 ' ' ' $8',2 FRONT PANEL Speakers (left + right) = Power On / Off = Volume -/+ CH = Program -/+ = Headphone 3,6 mm Ø S-VIDEO Remote Control Indicator VIDEO Sound Indicator AUDIO (L/S/G/I) = Audio left Power Indicator AUDIO (R/D/D/D) = Audio right Speaker Covers Antenna Connections -6-
Preparation Place TV on a solid surface. For ventilation, leave a space of at least 10 cm free all around the set. To prevent any fault and unsafe situations, please do not place any objects on top of the set. Use this apparatus in tropical and moderate climates. 2. Insert two batteries 1.5 V (R03 AAA size). Be sure to match the battery +/- terminals with the +/- marks inside the compartment.
Initial Settings The message PLEASE CHECK ANTENNA CABLE AUTO. PROGRAMMING SYSTEM will be displayed when you turn on your TV for the first time. $872 352*5$00,1* 6<67(0 (1* /,6+ &28 175< ( 781,1* 02' ( &+$ 11(/ Operating with the onset buttons Volume setting and programme selection can be made using the buttons on the right side of the TV. 3/($6( &+(&. $17(11$ &$%/( /$1* 8$*( You can delete a channel, insert a channel into a programme number, or re-start A.P.S. with the PROGRAM menu.
Menu System 92/8 0( Your TV has been designed with a menu system. Display MENU (main menu) and enter one of five menus (SOUND, PICTURE, FEATURE, INSTALL. and PROGRAM.). 1- Press M button to display MENU (main menu). The menu titles will be displayed in the main menu. 2- Press or button to select a menu title, then press or button to enter the menu.
Equalizer Picture Menu To enter Equalizer sub-menu, select Equalizer using or button, then enter Equalizer menu pressing or button. To change picture settings: 92/8 0( %$/$ 1&( 628 1' 0 2'( 02 12 :,'( 68552 81' 2)) To enter PICTURE menu directly, press the GREEN button, or Press M button, now you are in main menu. In the main menu, select PICTURE using or button, then enter the picture menu pressing or button.
Wide Mode : Using or button select Wide Mode. With this item you can select the width of the picture. By pressing or button you may choose one of these options : AUTO, 4:3 or 16:9. %5,*+71( 66 &21 75$67 &2/2 85 6+$5 31(66 3,&785( 02' ( 0$ 18$/ &2/2 85 7(03 125 0$/ : ,'( 02' ( $872 Wide mode can be set by wide mode button also. Setting Sharpness: Using or button select Sharpness. %5,*+71( 66 &21 75$67 Press button to increase Sharpness level.
4:3 You can watch 4:3 programs in 4:3 format by switching to 4:3 Mode function. 6/((3 7,0(5 2)) &+,/' /2&. 2)) /$1* 8$*( (1* /,6+ (;7 287387 79 %/8( % $&.*5 281' 21 Language: Menu Language can be selected by pressing or button on Language item. To Store the Settings Press or button on STORE option to store Picture menu settings or press OK button. 6/((3 7,0(5 2)) &+,/' /2&. 2)) /$1* 8$*( (1* /,6+ (;7 287387 79 %/8( % $&.
1. PROGRAMME is the first selected item as you enter the INSTALL. menu. Press the or button to select the programme number where you want the tuned channel to be stored. (You may also type the programme number using the digit buttons) Note: Do not use the PROGRAMME item when you want to modify the current programme number setting as this may cause other programmes to be changed that are in the existing programme number. 2. Press or button to select Tuning Mode.
Note : Channel Search Tuning Mode uses a channel table. The channels and stations at the table may vary from table to table and from country to country. Each channel has an exact frequency on the table. Frequency Search Tuning Mode does not use a channel table and it is slower than Channel Search Tuning Mode. Channel Search Tuning Mode is recommended for the countries which uses standard channel table. Frequency Search Tuning Mode recommended for the countries which uses non-standard channel table.
The selected page number is displayed at the top left corner of the screen. The Teletext page counter searches until the selected page number is located, so that the desired page is displayed on the screen. Other Features Sound Mute To cut off the sound from the TV press button. To restore + or the sound press the button again or use the buttons, in this case the volume will start from minimum setting. Press button to move the Teletext screen forward one page at a time.
To Select a Subcode Page Via the RCA jacks Subcode pages are subsections of long Teletext pages that can only be displayed on the screen one section at a time. Select the required Teletext page. Press button. Select the required subcode page number by pressing four digit buttons (e.g. 0001). If the selected subcode page is not displayed in a short time, press button. TV programme will be displayed on the screen.
Connecting external equipment Before connecting anything Switch off all equipment. Read the manuals provided with the equipments. To select an AV mode Pressing (;7 button on the remote control selects one of AV modes (EXT-1, RGB, EXT-2, F-AV, SVHS) To return to the TV mode, repeatedly press (;7 button. EXT.1 (EXT-1) terminal: Euroconnector (21-pin, SCART) Video input, Audio L/R inputs and RGB inputs are available. TV broadcast outputs (Video and Audio L/R) are available. EXT.
Typical Connections $HULDO FRQQHFWLRQ 79 VHW RQO\ %$&. 2) 79 $HULDO 1RW VXSSOLHG $1 7 ( ( $17 ;7 ;7 ( ; 7 ( ; 7 $HULDO /HDG 1RW VXSSOLHG $HULDO ,1 $HULDO &RQQHFWLRQV 79 DQG 9&5 $HULDO ,1 %$&. 2) 79 $17 $HULDO 1RW VXSSOLHG ( ; 7 ( ; 7 $9 7(50,1$/ $9 6FDUW /HDG 1RW VXSSOLHG $HULDO /HDG 1RW VXSSOLHG %$&.
Typical Connections (Continued) &RQQHFWLRQV 79 '9' 3OD\HU '(&2'(5 DQG 9&5 9LGHRUHFRUGHU %$&. 2) 79 '9' 3/$<(5 '(&2'(5 $1 7 (; 7 (; 7 6FDUW /HDG 1RW VXSSOLHG $HULDO ,1 $9 7(50,1$/ 6FDUW /HDG $9 1RW VXSSOLHG $9 7(50,1$/ $HULDO $9 1RW VXSSOLHG 6FDUW /HDG 1RW VXSSOLHG $HULDO /HDG 1RW VXSSOLHG %$&.
Typical Connections (Continued) &RQQHFWLRQV 79 '9' 3OD\HU DQG 'LJLWDO 6HW 7RS %R[ %$&.
Typical Connections (Continued) &RQQHFWLRQV 79 '9' 3OD\HU 9&5 DQG 'LJLWDO 6HW 7RS %R[ %$&. 2) 79 '9' 3/$<(5 $1 7 6FDUW /HDG (; 7 (; 7 1RW VXSSOLHG $HULDO ,1 $9 7(50,1$/ $9 $17 ( ; 7 ( ; 7 6DWHOOLWH GLVK 1RW VXSSOLHG $HULDO $HULDO /HDG 1RW VXSSOLHG 1RW VXSSOLHG 6FDUW /HDG 1RW VXSSOLHG %$&.
Typical Connections (Continued) )URQW FRQQHFWLRQV 79 DQG 9LGHR FDPHUD )5217 $9 %HKLQG WKH GRRU 6 9LGHR OHDG +L < & 1RW VXSSOLHG 6 9LGHR +L < & ,QSXW 7HUPLQDO 9,(: &$0 9LGHR ,QSXW 7HUPLQDO $XGLR ,QSXW 7HUPLQDO OHIW $XGLR ,QSXW 7HUPLQDO ULJKW &RQQHFWLRQ 79 SRZHU FDEOH WR D a 9 V\VWHP %$&. 2) 79 0DLQV 6RFNHW 2XWOHW $& a 9 +] $1 7 ( ;7 ( ; 7 Note: For further details, please refer to operation manual of your Video Camera.
21-pin Euro-SCART and 21-pin Audio/Video REAR TV RF Input 1. Aerial terminal ( ; 7 21-pin In/Out ( ; 7 2. 21-pin Audio/Video (RGB) (EXT.1) With PAL/SECAM/NTSC Video Input 3. 21-pin Audio/Video (EXT.2) With PAL/SECAM/NTSC Video Input 21-pin Euro-SCART with RGB Input (EXT.1) 1. Audio right output 2. Audio right input 3. Audio left output 4. Common earth for audio 5. Earth for blue 6. Audio left input 7. Blue input 8. Audio-video control 9. Earth for green 10. Not used 11. Green input 12.
Troubleshooting The following conditions do not always denote trouble. Therefore, performs the checks described below before calling for service. If the problem cannot be corrected by the use of this guide, pull the power plug out from the electrical outlet and call for service.
Specifications TV BROADCASTING PAL SECAM B/G D/K L/L RECEIVING CHANNELS VHF (BANDI/III) UHF (BAND U) HYPERBAND CABLE-TV (B/G : S01-S41 / S75-S79 D/K : S01-S19, S22-S41 L : S01-S41 / S75-S77) Cleaning The Screen Your TV is fitted with a True Flat" picture tube. The surface of the screen is covered with a foil. Under no circumstances may this be damaged. To clean Clean the laminated screen with a soft cotton cloth.
R 50053219 05/04 50053219 SHARP CORPORATION
Using the Speaker Covers The supplied speaker covers can be attached to the speakers on the TV set. NOTE • Use both hands when attaching or removing the speakers covers. • Depending on the attachment of the speaker covers on in cases of extreme temperature changes, the speaker covers may not perfectly align with the surface of the speakers. If this occurs, gently press the speaker covers with the palm or your hand to readjust the position.
Using the Speaker Covers (Continued) Removing the Speaker Covers 1 1- Hold the top part of the speaker cover and gently pull it toward you until the top attachment pins on the upper rear part of the speaker cover become reed. 2- Grasp both sides of the speaker cover and gently pull it toward you. 2 3- Grasp the bottom part of the speaker cover and gently pull it off. • The attachment pins on the lower rear part of the speaker become freed. 3 4- Remove the other speaker cover using the same procedure.
4
5
7
50053624
