Service manual

24
24
GB
Extreme condensation inside
the refrigerator
> Controller is set at a very cold
position
> Set the controller to a warmer
position & check to see if
compressor stops as should.
> The outside environment’s
relative humidity is very high
(over 75%)
> This type of occurrence is
caused by local climatic
conditions and not by the
refrigeration unit.
> The refrigerator door won’t shut
completely
> Check the door and/or the
magnetic gasket. Adjust the
door hinges if needed; replace
the gasket if broken.
> The refrigerator had been placed
at an inadequate location
> The unit must not be near
sources that produce too
much heat.
Condensing unit runs
for
long periods of time
> Excessive amount of warm
product placed in cabinet
> Advise user to leave adequate
time for products to cool down
> Prolonged door opening or door
ajar
> Advise user to ensure doors
are closed when not in use
and to avoid opening doors for
long periods of time.
> Door gasket(s) not sealing
properly
> Ensure gaskets are snapped in
completely. Remove gasket
and wash with soap and
water. Check condition of
gasket & replace if necessary
> Dirty condenser coil
> Clean condenser coil
> Evaporator coil iced over
> Unplug unit and allow coil to
defrost. Make sure thermostat
is not set too cold. Ensure that
door gasket(s) are sealing
properly. Select manual
defrost and ensure system
works.