Service manual

7
21HS-50H
No. OSD Function Range Initial Default FIX/ADJ
1 AGC AGC Take Over Point 0...63 14 14 ADJ
2 V-LIN Vertical Slope [VS] 0...63 32 32 ADJ
3 V-AMP Vertical Amplitude [VA] 0...63 32 32 ADJ
4 V-CENT Vertical Shift [VSH] 0...63 32 32 ADJ
5 H-CENT Horizontal shift [HS] 0...63 32 32 ADJ
6 H-CENT60 offset to H-CENT for60 Hz 0...31 data(-16..+15) 16 20 FIX
7 EW / / Horizontal Parallelogram [HP] 0...63 32 32 FIX
8 HB Horizontal Bow 0...63 32 32 FIX
9 S-COR S-Correction [SC] 0...63 0 22 FIX
10 DRI-RS White point Red Standard white temp. 0...63 32 42 ADJ
11 DRI-GS White point Green Standard white temp. 0...63 32 42 ADJ
12 DRI-BS White point Blue Standard white temp 0...63 32 42 ADJ
13 DRI-RW White point Red Warm white temp. 0...32 16 16 FIX
14 DRI-GW White point Green Warm white temp. 0...32 16 9 FIX
15 DRI-BW White point Blue Warm white temp. 0...32 16 9 FIX
16 DRI-RC White point Red Cold white temp. 0...32 16 9 FIX
17 DRI-GC White point Green Cold white temp. 0...32 16 9 FIX
18 DRI-BC White point Blue Cold white temp. 0...32 16 16 FIX
19 SUB-VOL Max Volume 0...63 60 60 FIX
20 SUB-CON Sub Contrast 0...63 63 63 FIX
21 SUB-COL Sub Colour 0...63 32 25 FIX
22 SUB-BRI Sub Brightness 0...63 32 34 FIX
23 TINT Sub Tint 0...63 32 32 FIX
24 SUB-SHP Sub Sharpness 0...63 32 11 FIX
• SERVICE ADJUSTMENTS AND DATA LIST
The table below shows the various service mode positions, range of values and default value. The columns are headed
as follows.
Heading: Description:
OSD This is what will appear on the screen when at this position
Function This is the description of the mode’s function
Range This is the range of values that can be entered while in this mode
Initial This is the initial value, i.e. just after changing the NVM
Default This is the recommended default value for this mode
FIX/ADJ If this is ADJ, then it may be necessary to adjust this value away from the default