Specifications

4 Replacement Procedures 4.13 Parallel port board / Serial port board / S-Video board
4-44 [CONFIDENTIAL] Satellite A50S/TECRA A3X Maintenance Manual (960-534)
4.13.3 S-Video board
Removing the S-Video board
The following describes the procedure for removing the S-Video board (See Figure 4-27, 4-
30).
NOTE: The procedure 1 and 2 are the same items as parallel port board. Refer
to the figure 4-27 in the parallel port board.
1. Remove the DC-IN jack and core from the slot of the base assembly.
2. Remove the following screws to remove the harness holder.
? M2.5x4B THIN BIND screw x2
3. Disconnect the USB harness from the connector PJ4610 and the S-Video harness
from the connector PJ5640 on the S-Video board.
4. Remove the S-Video board by lifting it
Figure 4-30 Removing S-Video board
PJ5640
USB harness
PJ4610
S
-
Video board
S
-
Video harness