Operator`s manual

OPERATION

Form 169000 / 169040 81 Revision C

6.17.5.4 Reel Vertical Position: A40-D

a. Open LH endshield.

b. Loosen the four nuts (E).

c. Loosen jam-nuts on adjuster bolts (F), and turn

bolts (F) to raise or lower reel.

NOTE

Adjustment at forward adjuster bolt

should be 0.47 in. (12 mm) lower than at

rear adjuster bolt.

d. Tighten jam-nuts.

e. Tighten nuts (E).

f. Open RH endshield.

g. Loosen the four nuts (G).

h. Loosen jam-nuts on adjuster bolts (H), and turn

bolts (H) to adjust reel “vertical” position.

i. Tighten jam-nut.

j. Tighten nuts (G).

k. Close shields before engaging header.

l. Check that the reel rotates freely.

IMPORTANT

Manually rotate reel and ensure that tines

do not

contact header pan, otherwise

damage to pan will result.

If necessary, grind off excessive length

from tine if tine length varies considerably.

Remove any sharp edges or burrs from

tine.

m. Check that the reel is evenly adjusted.