Operator`s manual

OPERATION
Form 169000 / 169040 62 Revision C
6.15 STEERING: PULL-TYPE
Steering the mower conditioner is controlled by
the tractor remote hydraulic system. This
steering system allows the mower conditioner to
follow directly behind the tractor, make a full cut
to either side, or any position in-between.
IMPORTANT
Hoses should be connected so that
moving tractor control lever (A)
FORWARD steers the machine to the
RIGHT, and moving the lever (A)
BACKWARD steers the mower
conditioner LEFT.
IMPORTANT
To allow APT to swing, the valve on the
APT must be in the “working” or “open”
position (handle in line with APT), and the
temporary transport lock pin must be in
the storage location.
The center pivot provides the Operator the
opportunity to:
• easily move the mower conditioner into the
“field” position,
• make right angle turns in either direction,
• steer around objects on both sides and
• do straight line field cutting on either side of
the tractor.
The control is operated momentarily for
steering, and must
be returned to OFF or
NEUTRAL position as soon as the mower
conditioner reaches the desired path of travel.
6.15.1 Right Side Operation: Pull-Type
Move steering lever FORWARD to achieve
desired position of mower conditioner on RIGHT
side of tractor.
To adjust tracking of mower conditioner during
right side operation, the steering cylinder clevis
can be re-positioned:
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Shutdown the tractor, and remove the key.
b. Loosen clamping bolt (B) on clevis (C).
c. Using a wrench on the stroke control (B), rotate
cylinder rod so that the clevis moves away from
or closer to the cylinder. Each turn of the rod
changes the tracking by approximately 2 in.
(50 mm).
DESIRED
TRACK
CYLINDER
EXTENSION
CLEVIS POSITION
Further RIGHT Increase
Clevis (C) Further From
Cylinder
Further LEFT Decrease
Clevis (C) Closer To
Cylinder
d. Tighten clamping bolt to 65 ft·lbf (90 N·m).
e. Re-check torque on clamping bolt after 1 hour,
and every 100 hours thereafter.
A
B
C