Operator`s manual

OPERATION
Form 169000 / 169040 57 Revision C
IMPORTANT
The APT must not widen the shipping
package.
j. Secure APT to frame hook to prevent
movement. Use cardboard or suitable material
under the tie to protect paint.
k. Secure the steering cylinder to the frame with
wire. Wrap tie around clevis, and use cardboard
or suitable material under the tie to protect paint
on the frame.
CAUTION
Equipment used for unloading must meet or
exceed the requirements specified below.
Using inadequate equipment may result in
chain breakage, vehicle tipping or machine
damage.
Lifting Vehicle
:
Minimum Lifting Capacity: 8500 lb (3865 kg)
Minimum Lifting Height: 15 ft (4.5 m)
Chain:
Type: Overhead Lifting Quality (1/2 in)
Minimum Working Load: 5000 lb (2270 kg)
l. Attach a chain to each frame hook (K) and a
chain to each end of the lean bar at (L). Chain
must
pass through hole at end of lean bar.
m. Position forklift from either front or back of
mower conditioner, and lift slightly off the
ground.
n. Remove the wheels by removing bolt (M), and
pulling wheel/axle assembly from frame.
o. Lift mower conditioner, and back the flatbed
trailer under the unit. The mower conditioner
can be positioned with the APT towards the front
or rear of the flatbed.
(continued next page)
M
L
K