Operator`s manual

OPERATION
Form 169000 / 169040 32 Revision C
6.4.3 Hydraulic Connections
WARNING
Do not use remote hydraulic system
pressures over 3000 psi (20684 kPa). Check
your tractor Operator’s Manual for remote
system pressure.
SYSTEM HOSE
TRACTOR
HYDRAULICS
Steering
A (2 Hoses) Control 1
Lift
B (1 Hose) Control 2
Header Tilt
C (2 Hoses) Control 3
NOTE
Arrows cut into plate indicate system for
hoses. LIFT STEERING
a. Ensure hoses are routed through guide (E) to
provide proper hose arc as shown.
b. Connect two steering cylinder hoses (A) as
follows:
CONTROL
LEVER
POSITION
CYLINDER
MOVEMENT
MOWER-
CONDITIONER
DIRECTION
Forward
Extend Right
Backward
Retract Left
c. Connect one lift cylinder hose (B) as follows:
CONTROL
LEVER
POSITION
CYLINDER
MOVEMENT
HEADER
MOVEMENT
Forward
Retract Lower
Backward
Extend Raise
d. Connect two header tilt cylinder hoses (C) as
follows: (Not required with mechanical center
link).
CONTROL
LEVER
POSITION
CYLINDER
MOVEMENT
HEADER
MOVEMENT
Forward
Retract Lower
Backward
Extend Raise
e. Connect the mower-conditioner wiring harness
connector (D) to tractor. The connector is
designed to fit tractors equipped with a round
7-pin receptacle (SAE J560).
IMPORTANT
Older model tractors will have Pin #4 (F)
energized as an accessory circuit. The
mower conditioner uses this pin position
(G) for brake lights. Check that Pin #4 in
the tractor receptacle is not constantly
energized – see tractor Operator’s
Manual, and remove the appropriate fuse
if required.
B
A
C
F
G
E
B
D
C
A