Operator`s manual

OPERATION
Form 169000 / 169040 28 Revision C
6.3.4 3 Point Hitch (Cat. II, III, or IIIN) Set-
Up
a. Attach the 3 point hitch yoke (A) to the APT with
pin (B). The installation is similar to that
described in the previous section.
b. Secure pin (B) with clevis pin (C), washers, and
cotter pin.
c. The arms (D) on APT yoke can be set up to suit
the tractor hitch arms:
1. Remove pins (E) from arms.
2. Remove arms (D) from APT yoke.
3. Re-install arms on opposite ends of yoke as
shown.
4. Re-install pins (E) in arms.
NOTE
Bushings (F) on pins can be removed to
suit hole size in tractor hitch arms.
d. Assemble PTO driveline male half (G) onto PTO
shaft (H) on APT. Push male half so that PTO
shaft is at its “fully compressed” length.
e. Locate PTO shaft in hook (J).
CATEGORY III
CATEGORY II or IIIN
D
E
F
B
C
A
G
H
J