Operator`s manual

MAINTENANCE AND SERVICING
Form 169000 / 169040 167 Revision C
h. Remove the auger drive pulley (K) as follows:
1. Remove the three bolts (L) from hub (M),
and remove hub and sprocket.
2. Remove the three bolts (N) from the tapered
bushing.
3. Install bolts in the two threaded holes in
bushing, and tighten to release the bushing.
4. Remove the pulley (K), bushing, and key.
i. Remove the two bolts (O), and nut and bolt (P)
attaching channel (Q) to end sheet, and remove
channel (Q).
j. Remove the three flanged lock nuts (R) that
secure gearbox (S) to header end sheet, and
remove gearbox.
O
Q
P
N
K
L
K
M
R
S