Operator`s manual

MAINTENANCE AND SERVICING
Form 169000 / 169040 162 Revision C
c. Lift forming shield onto bolts (N) in windrower
legs, and secure with clevis pins (M) and hairpin.
d. Lift the aft end of the forming shield and attach
straps (O) to pins (P) on windrower frame.
Install washer and hairpin to secure strap. Use
the middle hole and adjust height to suit the
crop.
e. Set forming shield side deflectors to desired
width by re-positioning adjuster bars (Q). Use
same hole location on both sides.
f. Adjust fluffer shield (R) to middle position.
Loosen handles (S) if required.
7.13.6 Hydraulic Drive Motor Removal: All
Models
a. Open shield covering conditioner drive.
b. On pull-type machines, disconnect the hydraulic
hoses from the motor, and install caps on hose
ends and motor ports.
c. On self-propelled machines, disconnect hoses at
couplers on motor.
d. Remove the two bolts (A) securing motor to
gearbox, and remove motor.
7.13.7 Hydraulic Drive Motor Installation:
All Models
Install the hydraulic drive motor onto the
gearbox (A) as follows:
a. Clean off excess sealant from motor flange and
gearbox face.
b. Apply light coat of silicone to motor flange, and
position motor on gearbox as shown until
mounting holes are aligned, and pinion engages
gear in gearbox.
c. Install bolts (A) and washers and torque to
75 ft·lbf (102 N·m).
d. Re-connect hoses to motor.
A
O
P
M
N
BOTH SIDES
R
S
Q