Operator`s manual

ManualsBrandsSharp ManualsTV21F-A30

161

162

163

164

165

166

167

168

169

170

MAINTENANCE AND SERVICING

Form 169000 / 169040 159 Revision C

7.11.7.2 Stripper Bar Replacement

WARNING

To avoid bodily injury or death from

unexpected start-up or fall of raised

machine, stop engine, remove key, and

engage lift cylinder stops before going under

machine.

a. Remove the four nuts and bolts (A) that secure

each stripper bar (B) (left hand and right hand)

to the pan, and remove bars. There are six bars

in total.

b. Position new bars (B) on pan as shown, with

upper flange on front bar facing forward.

c. Install three bolts and nuts (A) in each bar, and

torque to 150 ft·lbf (203 N·m).

d. Check clearance between auger and stripper

bars.

e. Loosen bolts (A), and add shims between

stripper bars and pan at bolt locations as

required to obtain clearance as shown.

f. Re-tighten bolts to specified torque.

7.11.7.3 Front Stripper Bar Extensions

Extensions for the front stripper bar are provided

for installation if required for certain crop

conditions, or especially in tall crops, that cause

the material to bunch up at the ends of the

conditioner rolls.

The stripper bar extensions will allow the auger

to carry the crop “more toward the center”,

rather than prematurely feeding it to the

conditioner.

a. Raise header, and engage lift cylinder stops.

b. Remove nuts and carriage bolts (C) securing the

two extensions (D) to underside of header pan

support, and retain for re-installation.

c. Position extension (D) at inboard end of front

stripper bars (E), and mark locations of the two

holes onto the plastic pan.

d. Drill two 5/16 in. (8 mm) holes at these locations.

e. Install extension with carriage bolts (C) removed

at b.

f. Repeat above steps for other extension.

7.12 AUGER AND AUGER DRIVE: A40-D

The A40-D header auger is driven directly from

a hydraulic motor, and there are no belts or

chains to maintain.

For auger and stripper bar maintenance

procedures, refer to Section 7.11.5 Auger Pans,

Section 7.11.6 Rubber Fingers, and Section

7.11.7 Stripper Bars.

LH SIDE

(AUGER NOT SHOWN FOR CLARITY)

FWD